News

Modification with two-row and 7-seats cabin is the most demanded equipped with Fuhrmann (Austria) onboard platform and Amco Veba 807 NT 2s crane-manipulator on the rear overhang. Rear cabin compartment is equipped with door on the right hand to direction of motion. Front cabin compartment includes 3 regular seats for passengers including the driver seat, the rear compartment contains 4 seats with reclining seats and shelf for hand luggage. Passengers of two cabin compartments can communicate due to the sliding window. The area of rear section of the cabin is enough for comfortable landing and unloading, and does not restrict the movements of humans, so there is the possibility to stand almost in full growth and dress up in the cabin. The original system of cabin lifting due to the telescopic cylinder and hand pump allows to get the quick access to major components of the machine and simplifies the conducted of planned maintenance. Angle of elevation is 45 °. Fuhrmann platform with steel sides applied on the truck has greater strength and reliability compared to aluminum sides that allows the carriage of different loads. CMI location on the rear overhang extends the work zone, gives the possibility to drive up close to the load using maximum manipulator facilities concerning with bearing capacity, as well as there is the opportunity to work with the hindcarriage. Assembly machine includes the cabin heater, pre-start engine preheating, 2 tool boxes, reinforced springs, 2 additional pipeline under hydrotool, and hatch for checking of oil level. Spotlight installed at CMI thanks to which you can work even at night.